Wolf Legacy E Series Oven Code 07 x 24: What It Means and What to Check
If 07 x 24 appears on your Wolf Legacy E Series Oven, treat it as a clue from the appliance's monitoring system. One safe reset and a few non-invasive checks may rule out a temporary condition; a recurring code deserves model-specific diagnosis.
Written by
Ethan Cole Appliance Repair Content SpecialistPublished September 1, 2026
Content status:
Reviewed
Error code07 x 24
ApplianceLegacy E Series Oven
Quick answer
On this Wolf Legacy E Series Oven, code 07 x 24 is associated with DLB2 relay open. If it returns after one safe, non-invasive check or reset, the underlying condition still needs diagnosis.
Model compatibility: Wolf reuses codes across series and model years, so 07 x 24 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
DLB2 relay open
Signs
Symptoms you may notice
One heating mode or cavity may heat poorly, not heat at all, or stop shortly after starting.
The code may appear when the control commands a heating load and does not see the expected response.
A specific bake, broil, convection, or warming function may be affected while other modes still operate.
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Stop the affected cooking mode and allow the appliance to cool.
Perform one power reset only if the breaker has not tripped and there is no burning smell, smoke, or abnormal heat.
Note which cavity, element, or mode fails to heat or triggers the code.
Important safety warning. Safety first: stop using the appliance and disconnect power only if it can be done safely if you notice smoke, a burning smell, arcing, repeated breaker trips, abnormal heat, gas odor, or water near electrical parts. Internal electrical, gas, steam, and high-temperature diagnostics should be left to a qualified technician.
Please avoid
What not to attempt
Do not jumper relays, bypass thermal protection, energize exposed elements, or test live high-voltage circuits.
Get help
When to call a technician
If 07 x 24 returns after one safe reset, stop using the affected heating mode. A technician should verify the load, switching device, wiring, temperature protection, and control output before deciding what needs replacement.
Seeing this code on your Wolf appliance?
Book a specialist visit for a clear estimate and approval before any repair. Independent service — not an official Wolf service center.
On the Legacy E Series Oven, the documented meaning of 07 x 24 is DLB2 relay open. A technician still needs to verify the circuit, connection, sensor, load, or control involved before recommending a component replacement.
Not by itself. An error code identifies a system, circuit, state, or monitored condition. Wiring, connectors, power, installation conditions, sensors, loads, and controls can produce similar symptoms, so testing should come before parts replacement.
That depends on the symptom. Stop using the appliance immediately for smoke, a burning smell, repeated breaker trips, gas odor, abnormal heat, sparks, or water near electrical parts. Otherwise, avoid the affected mode until the recurring code has been diagnosed.
Ready to get your Wolf appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
